Energy Efficient Hot Tubs: What to Look For
Energy efficient hot tubs keep their heat in. Here is what to look for
A hot tub loses heat up through the water's surface, out through its cabinet and away on the wind. An efficient tub, set up well, closes each of those routes.1,2
This guide covers the spec to check before you buy. Every model we sell is on our hot tubs page, with a selection on our energy efficient hot tubs page, and our guide to hot tub running costs works out the cost per day.
Five things to check before you buy
Foam insulation in the cabinet
Our Comfort hot tub has closed-cell insulation foam under the shell.3 Jacuzzi hot tubs use foam insulation as part of a layered heat retention system that also recycles heat from the pumps and parts back into the water, and in California Energy Commission testing they came out on average 22 percent more efficient than the standard requires.2
Heating modes that suit you
In Ready mode the tub checks the water and heats whenever it needs to. In Rest mode it only heats during its programmed filter cycles.3
Room for a heat pump
Tubs such as our Comfort work with an air source heat pump, which adds heat taken from the outside air.3,4 Our guide to heat pump sizes matches one to your tub.
A sheltered spot
Wind cools the water and makes the tub work harder. Near a wall, close to the house or under partial shelter, it holds its heat better.2
The cover does most of the work
Keep it on while it heats
Keeping the cover on while the water heats up gets it to temperature faster, and locking it when the tub is not in use keeps the heat in.2 Our hot tub covers page has replacements for many models.
Check it now and then
Look for water soaking into the cover and for tired insulation, because a cover in good condition holds more heat.2 Our guide on when to replace a hot tub cover shows the signs.
Lift it off the ground
A cover lifter keeps the cover off the ground and away from dirt while you soak.3 Our cover lifter guide shows which one fits.
Leave the air controls closed while it heats
Air drawn into the jets cools the water, so keeping the air controls closed while the tub heats saves energy.3
Spec sheet words, in plain English
These are the terms you will see on a hot tub's spec sheet and control panel, and what each one means for energy.
| On the spec sheet | What it means |
|---|---|
| Closed-cell foam | Insulation under the shell that helps hold the heat in.3 |
| Ready mode | Checks the water and heats whenever it needs to.3 |
| Rest mode | Heats only during the programmed filter cycles.3 |
| Filter cycle | A set run of the pump to clean the water, usually once a day, starting 6 minutes after the tub is switched on.3 |
| Heat pump compatible | The tub can be paired with an air source heat pump.3 |
| Max power consumption | The most the tub draws at once with everything running, such as 2.15 kW on our Comfort. Daily use is counted in kWh, which our running costs guide works out.3 |
Adding a heat pump
An air source heat pump sits beside the tub and moves heat from the outside air into the water. Our 7 kW heat pump works in air temperatures from -7°C to 35°C and is designed to cut heating costs by up to 80 percent compared with conventional heating.4
It runs quietly at 54 dB(A), and in summer it can cool the water down to 8°C.4 Our air source heat pumps page has the full range.
Two efficient tubs and a heat pump
All new and on our site now. See every model on our hot tubs page.

Outdoor Living Comfort
£2,899 · 4 seats · 13 amp
Closed-cell foam under the shell, with Ready and Rest heating modes, on a plug-in supply.

Jacuzzi J-435 (2025 Model)
£11,999 · 6 seats · 32 amp
Jacuzzi's foam heat retention system, with a lounger and 45 jets.

Outdoor Living 7kW Heat Pump
£1,699 · works from -7°C to 35°C
Adds heat taken from the outside air, alongside your tub's own heater.
Questions about energy efficient hot tubs
Open a question to read the answer.
What makes a hot tub energy efficient?
A cover that fits tightly, foam insulation in the cabinet, heating modes that suit how you use it and a sheltered spot. A heat pump can add heat taken from the outside air.
Does a hot tub cover save energy?
Yes. More than 90 percent of a hot tub's heat escapes through the water's surface when it is uncovered, so a cover that fits tightly keeps most of it in.
What is Rest mode on a hot tub?
Rest mode only heats the water during the programmed filter cycles. Ready mode checks the water and heats whenever it needs to.
Is a heat pump worth it for a hot tub?
A heat pump moves heat from the outside air into the water. Our 7 kW heat pump works in air temperatures from -7°C to 35°C and is designed to cut heating costs by up to 80 percent compared with conventional heating.
Where should I put a hot tub to save energy?
Out of the wind, near a wall, close to the house or under partial shelter, so the water holds its heat better.
Sources
- Hydropool, How long does a hot tub take to heat up?, 4 September 2026.
- Jacuzzi UK, 5 energy efficiency considerations for your Jacuzzi hot tub, accessed 13 November 2026.
- Outdoor Living, Comfort hot tub manual: insulation, heating modes, filter cycles and specification, February 2026.
- Outdoor Living, 7kW air source heat pump for hot tub or swim spa, accessed 13 November 2026.








