How Long Does a Hot Tub Take to Heat Up?
How long does a hot tub take to heat up? About 3 to 8 hours from a fresh fill
Once the heater is running, water usually rises by about 3 to 6°C an hour, and a top-up after a soak takes 30 to 60 minutes.1 Fill it in the evening and it is ready by morning.
The size of the tub and the power of its heater set the time, so a small 13 amp tub and a large 32 amp tub heat at different speeds. The night chart below works out three of ours, and our hot tubs page lists the heater and the litres for every model.
The short answer
- 3 to 8 hoursto heat a fresh fill to soaking temperature1
- 3 to 6°Cthe usual rise in an hour once the heater is running1
- 30 to 60 minto bring it back up after a soak and a top-up1
A mild day, warmer fill water and a good cover put you at the short end. A cold night or the cover left off puts you at the long end.1
Work it out for your tub
Every litre of water takes about 0.00116 kWh to warm by one degree.2 Multiply that by the litres in the tub and the degrees you need, then divide by the heater's power in kW. The answer is the heating time in hours.
The chart above uses tap water at 15°C heated to 38°C, a rise of 23 degrees, with the heater and litres from our product pages.3,4,5
| Hot tub | Water | Heat source | Energy for 23°C | Time |
|---|---|---|---|---|
| Outdoor Living Harmony | 480 litres | 2.1 kW heater | 12.8 kWh | about 6 hours |
| Outdoor Living Sanctuary | 1,400 litres | 3 kW heater | 37.4 kWh | about 12½ hours |
| Sanctuary with a heat pump | 1,400 litres | 7 kW heat pump | 37.4 kWh | about 5½ hours |
These are the times on paper, with every kWh going into the water. On the day, some heat leaves through the surface and the cabinet, so allow a little longer, more so on a cold or windy night.1
What sets the time
The water you start with
Tap water starts cold, and every degree it has to climb adds time. A tub only being topped up after a soak is already close to temperature, which is why that takes under an hour.1
The heater, and the supply behind it
A 13 amp supply carries about 3 kW in total, so plug-in tubs use smaller heaters, such as the 2.1 kW heater in the Harmony.3,6 A 32 amp tub runs a larger heater alongside its pumps, such as the 3 kW heater in the Sanctuary.4 Our 13 amp and 32 amp guide explains the supply.
The cover
More than 90 percent of a hot tub's heat escapes through the water's surface when it is uncovered, so the cover does most of the work of keeping heat in.1
Five ways to get in sooner
Start the night before
Filling the day before you want to soak lets the heater work overnight.1
Keep the cover on while it fills
Keeping the cover mostly closed during the fill helps the water start warming sooner.1
Choose the right mode
Set a mode that heats on demand, such as Standard on a Balboa panel, while you bring a fresh fill up to temperature.8
Give it shelter
Windbreaks and planting around the tub cut the heat that wind carries away.1
Add a heat pump
An air source heat pump adds heat of its own. Our 7 kW heat pump works in air temperatures from -7°C to 35°C.5 Our guide to heat pump sizes matches one to your tub.
Two tubs and a heat pump from the chart
All new and on our site now. Every model we sell, with its heater and water volume, is on our hot tubs page, and our 13 amp hot tubs are grouped together.

Outdoor Living Harmony
£2,599 · 480 litres · 2.1 kW heater
A two-seat 13 amp tub with a small volume of water, so it heats in about six hours from a fresh fill.

Outdoor Living Sanctuary
£6,499 · 1,400 litres · 3 kW heater
Seven seats on 32 amp. Fill it in the evening for a morning soak.

Outdoor Living 7kW Heat Pump
£1,699 · works from -7°C to 35°C
Adds heat alongside your tub, which shortens a fresh fill on larger tubs.
Questions about heating a hot tub
Open a question to read the answer.
How long does a hot tub take to heat up?
From a fresh fill, about 3 to 8 hours. Once the heater is running the water usually rises by about 3 to 6°C an hour.
How long does a hot tub take to heat up after a top-up?
Usually 30 to 60 minutes, because the water is already close to temperature.
Why is my hot tub taking so long to heat?
The usual causes are very cold fill water, a cold or windy night, the cover left off, or an economy or sleep mode that only heats during filter cycles.
Does a 13 amp hot tub take longer to heat than a 32 amp one?
Often, because a 13 amp supply carries about 3 kW in total, so plug-in tubs use smaller heaters. Smaller 13 amp tubs also hold less water, which shortens the time.
Can I use my hot tub while it is heating?
Yes, once the water is at a temperature you are comfortable with. Most people fill in the evening and soak the next day.
Sources
- Hydropool, How long does a hot tub take to heat up?, 4 September 2026.
- Case Western Reserve University, Specific heat and heat of fusion demo, accessed 13 November 2026.
- Outdoor Living, Harmony hot tub: 2.1 kW heater, 480 litres, accessed 13 November 2026.
- Outdoor Living, Sanctuary hot tub: 3 kW heater, 1,400 litres, accessed 13 November 2026.
- Outdoor Living, 7kW air source heat pump for hot tub or swim spa, accessed 13 November 2026.
- Institution of Engineering and Technology, Domestic electrical supplies to hot tubs, Geoff Cronshaw.
- Outdoor Living, Comfort hot tub manual, February 2026.
- Balboa Water Group, Balboa 500DZ-Series operation guide, 27 September 2011.








