Hot Tub Chemical Chart: The Levels to Aim For
Five readings keep hot tub water clear. Here is where each one should sit.
Dip a test strip, match the colours, then check each reading against the chart below. If one is out, the fixes further down tell you exactly what to add.
The hot tub chemical chart
The coloured band on each scale is where the reading should sit. Use chlorine or bromine as your sanitiser, not both, and keep the water at 40°C or below.2
If a reading is out of range
pH: aim for 7.2 to 7.6
Below 7.2, sanitiser is used up faster, surfaces and equipment can corrode and the water can sting. Above 7.6, chlorine works less well, scale can form and the water can turn cloudy.1
Low: add pH increaser (£7.49). High: add pH reducer (£8.49). Add a little, let it mix for 30 minutes with the cover off, then test again.1
Total alkalinity: aim for 80 to 120 ppm
Alkalinity helps hold the pH steady. When it is low, the water turns corrosive and the pH is hard to keep in range.4
Low: add alkalinity increaser (£7.99).
Chlorine level: aim for 3 to 5 ppm
Chlorine kills bacteria and keeps the water clean. Your test strip may call this reading free chlorine: the chlorine still active in the water. Keep it between 3 and 5 ppm, and wait for a high reading to drop back to 5 ppm before you soak.2
Low: add hot tub chlorine granules (£9.99), or start with our chlorine starter kit (£24.99).
Bromine: aim for 4 to 6 ppm
Bromine does the same job as chlorine and holds up well in hot water. Keep it between 4 and 6 ppm.2 Our own hot tub manuals give 2.2 to 3.3 ppm when bromine tablets sit in the pre-filter, so follow the range in your manual if it gives one.1
Low: add bromine granules (£17.99). A weekly dose of non-chlorine shock (£16.99) reactivates bromine as well.5
Calcium hardness: aim for 150 to 250 ppm
Water that is too soft can corrode pipes and fittings.6
Low: add hardness increaser (£8.49).
A simple testing routine
Test before you soak, and every day when the hot tub is busy.2 Our hot tub manuals ask for the pH to be checked daily, the water tested at home at least weekly and tested professionally once a month.1
Our 3-in-1 test strips (£4.99 for 50) read chlorine or bromine, pH and total alkalinity in one dip.7
When you add anything, run the pumps, give it 20 to 30 minutes to mix, then test again. Leave the cover off for at least 30 minutes after adding chemicals.1 Shock the water at least once a week as well.3
Use chemicals made for hot tubs only: pool-grade chemicals can damage the equipment.1 Everything on this page is in our hot tub chemicals range, and our guide to cloudy, foamy or green water helps when the water looks wrong.
Quick answers
Open a question to read the answer.
What should my hot tub chemical levels be?
Aim for pH 7.2 to 7.6, total alkalinity 80 to 120 ppm, chlorine 3 to 5 ppm or bromine 4 to 6 ppm, and calcium hardness 150 to 250 ppm. Keep the water at 40°C or below.
How often should I test my hot tub water?
Test before you soak, and daily when the hot tub is in heavy use. Check the pH daily and the sanitiser and other readings at least weekly, and have the water tested professionally once a month.
What do I add if my hot tub pH is too high?
Add pH reducer a little at a time with the pumps running, leave the cover off for 30 minutes while it mixes, then test again.
What is the right chlorine level for a hot tub?
Keep the chlorine level between 3 and 5 ppm. If it reads higher, leave the cover off and wait for it to drop back to 5 ppm before you get in.
Can I use pool chemicals in a hot tub?
No. Use chemicals made for hot tubs. Our hot tub manuals say pool-grade chemicals can damage the equipment and that damage is not covered by the warranty.
Sources
- Outdoor Living, Comfort hot tub owner's manual, water management and maintenance, 27 May 2025
- HealthLinkBC, Residential hot tubs and pools: safe water quality, 1 August 2024
- Leslie's, What chemicals do I need for a hot tub?, viewed 12 November 2026
- Outdoor Living, Hot tub total alkalinity increaser, viewed 12 November 2026
- Outdoor Living, Hot tub non-chlorine shock granules, viewed 12 November 2026
- Outdoor Living, Jacuzzi hot tub hardness increaser, viewed 12 November 2026
- Outdoor Living, 3-in-1 pool and hot tub test strips, viewed 12 November 2026
Rather we did it for you?
Our own service team visits hot tubs across Great Britain. Book online, then we call you to pick a date.
-
Drain, clean and fillDrained, cleaned inside and out, and refilled ready to heat. Ideal every 3 to 4 months.
£129View service
-
Annual hot tub serviceA 32-point check, a drain and clean, and a photo report. About two hours.
£179View service
-
Drain and winteriseDrained and readied for the cold, so water left in the pipes and pumps cannot freeze.
£129View service











